Forum Riservato agli Artigiani Riparatori TV elettronica telecomunicazioni titolari di Partita Iva - offerto da www.MariTV.net - Sinudyne 28E3A OPUS service mode cercasi
Forum Riservato agli Artigiani Riparatori TV elettronica telecomunicazioni titolari di Partita Iva - offerto da www.MariTV.net
Benvenuto Roberto, qui di seguito il SERVICE MODE. se preferisci ho la eprom pronta ! e se ti serve, ho anche lo schema
Activation of service mode 1. Power up the appliance by pressing the on-off switch simultaneously pressing and holding the MENU button of the cabinet controls until the green Led lights up. 2. Release the MENU button at the cabinet and press the stand-by button on the remote control; the appliance will default to programme 1, or to position AV1 if pin 8 of the SCART 1 socket is connect to a +12 V supply. Important: make certain that the test signal needed for adjustment purposes is available either on programme 1 or on the SCART 1 input, as any further selection of sources is not possible when in service mode. 3. The functions accessible in service mode are listed below; they are selected with the P+ and P– buttons of the remote control then adjusted with the Volume ± buttons. It is advisable to note down the initial value of each parameter before making any adjustment, so that it can be restored easily if necessary. In the event of the NVM memories being replaced, it will be necessary to carry out all of the envisaged service mode adjustments, as the replacement memory is supplied NOT pre-programmed and a new initialization is therefore indispensable.
WARNING. If a new NVM is installed, service mode will not allow the various parameters to be accessed until the initialization procedure has been completed. WARNING. Tuning is not possible before initialization.
Ecco comunque la procedura per il service mode Sinudyne Professional 2500 ( 28E3A opus ):
1)accendere il TV con l' interruttore di rete tenendo contemporaneamente premuto il tasto menù sul telecomando, fino a che si illumina il led verde
2)Rilascare il tasto menù e premere stand by dal dal TLC. Il Tv si accenderà sul programma 1 u su AV se è collegata la + 12 sul pin 8 della scart, quindi su uno di questi deve esseere disponibile un segnale di test per le regolazioni
3) selezionare le funzioni da regolare con i tasti P+ e P- e fare le regolazioni con Volume + e -. Meglio annotare il valore iniziale, prima di modificarlo, in modo da poterlo eventualmente ripristinare.
4)Per disattivare il modo serrvizio premere il tasto TV sul telecomando, che memorizzerà anche le nuove regolazioni
grazie ragazzi dei vostri preziosi consigli domani proverò ad entrare nel service mode e regolare la geometria dell immagine. la mia partita iva :01835010925 .Poi vi sapro sapere